elektr0
Full Member level 5
Hello,
we have a three layer PCB process and I am wondering if I can route DC signals on the bottom layer, which is screwed to the mechanical housing (GND) and is isolated by standard solder mask only (I guess 1 micron ?). What do you think ? Thank you for your help.
Regards
-e
we have a three layer PCB process and I am wondering if I can route DC signals on the bottom layer, which is screwed to the mechanical housing (GND) and is isolated by standard solder mask only (I guess 1 micron ?). What do you think ? Thank you for your help.
Regards
-e