farishamam
Newbie level 6
i am attempting to transmit a signal using loop antenna transmitter and receiver.
i am using two square loop antennas as transmitters each connected to a function generator (24Vp-p and 20mW power output), one is set to 200Khz and the other to 1500Khz.
the two transmitters are set opposite to each other and the receiving antenna is between them. when only one generator is turned on, the received signal is normal. however, when i turn both generators on, the received signal power is actually higher than that transmitted. (at one point, the total transmitted from the two generators was 40mW and the received signal was 60 mW !)
can anyone please explain this?
i am using two square loop antennas as transmitters each connected to a function generator (24Vp-p and 20mW power output), one is set to 200Khz and the other to 1500Khz.
the two transmitters are set opposite to each other and the receiving antenna is between them. when only one generator is turned on, the received signal is normal. however, when i turn both generators on, the received signal power is actually higher than that transmitted. (at one point, the total transmitted from the two generators was 40mW and the received signal was 60 mW !)
can anyone please explain this?