Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Question about transformer value used to design a regulated DC voltage source

Status
Not open for further replies.
L

Lucifre

Full Member level 2
Joined
Jul 5, 2005
Messages
125
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,296
Location
Detroit MI
Activity points
2,389
i hav a transformer that gives 16.38 V rms without load, and 12.6 V rms @ 300 ma
which of those values do i use to design a regulated dc voltage source that would give me 310 ma at 12 v?
 

Re: transformer question

You should use the second value (under nominal load)
Attached is a handy note on Rectifier Relationships..
Regards,
IanP
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top