yonzzan
Junior Member level 3
If the spec of my fully differential opamp contains slew rate is 20 v/usec, does that mean the slew rate in my design has to be greater or less than the value?
For example, does slew rate 300 v/usec in my design satisfy the spec?
Thanks ahead.
Another question, I need to build a CMFB to have my op amp operate. However, I do not know how to design it. such as Current flow , Vov, width and length of the circuit. I have not been found any book which shows how to design it. I am looking forward to hearing your advice.
Best Regards
For example, does slew rate 300 v/usec in my design satisfy the spec?
Thanks ahead.
Another question, I need to build a CMFB to have my op amp operate. However, I do not know how to design it. such as Current flow , Vov, width and length of the circuit. I have not been found any book which shows how to design it. I am looking forward to hearing your advice.
Best Regards