Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

psrr issues in ldo design

Status
Not open for further replies.

lxcpku

Junior Member level 3
Junior Member level 3
Joined
Sep 7, 2007
Messages
30
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,508
ldo design psrr

hi,all
i have some questions about psrr in ldo design
1. if there are 3 sub-modules in my ldo , then psrr of ldo depends on the minmum psrr of the sub-module ,is that right ?
2. first i checked my bandgap's psrr. i wanna a psrr of 60db@10k,however ,in my design, only 57db@10k. then i checked the psrr of the opamp used in bandgap.which is 60db@100k and meets my needs. so how can i improve my psrr of bandgap without increase the Ac gain of opamp

anyone could give me some advice ?
suggestions and advice will always be welcome, thx a lot :)
 

how to reduce psrr

You can check the following two theses:

A Capacitor-less Low Drop-Out Voltage Regulator

**broken link removed**


An Accurate, Trimless, High PSRR, Low-Voltage,CMOS Bandgap Reference IC

**broken link removed**
 

cmos ldo psrr design

i am not the member of ieeeclub and can not download the thesis you suggested :(
 

the membership is free. You just fill up the form to become a club member then you can download everything there for free.
 

you can cut the feedback point,and simulate the psrr of the whole circuit with the 3 subcircuits.
 

suppose your psrr is a total combined effect of your circuit. So you don't need to add all the psrr together (they are not noise power). All you have to do is make sure the signal path from supply to you output. Then run AC for psrr.
 

You can connect the BandGap supply at the LDO output, using a proper wake up circuit. This way the bandgap PSRR is not so critical.
 

you can connect a bypass capacitor at the output of your bandgap voltage externally to reduce psrr caused by bandgap circuitry
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top