Prototype pcb product line

mohammadyou · Jul 8, 2013

Hi
I am planning to launch the PCB product line. I am considering using some in-house prototype as a start point.
I would appreciate if you give me any useful information for producing 2 layer PCB. what kind of machines as well as their brand is more appropriate.
I have already seen LPKF equipment but their price is too expensive
Thanks in Advance.

tpetar · Jul 9, 2013

Major problem for home PCB makers is hole plating.

Here you can see one approach for solution :

Low cost PCB through-hole plating
http://dangerousprototypes.com/2013/05/15/low-cost-pcb-through-hole-plating/

I must say I didnt try this at home, but I usually use very thin wire or very small rivets.

Rivets
http://www.megauk.com/through_hole_rivets.php

Best regards,
Peter

mohammadyou · Jul 9, 2013

Thank tpetar
is there any cheap device that make a 2 layer PCB like this
https://www.lpkf.com/products/rapid-pcb-prototyping/why-rapid-pcb-prototyping.htm

tpetar · Jul 9, 2013

I dont think that there is cheap device, and also you need chem materials for hole plating.

"Cheap" is relative size and depends from spectator and potential user budget.

Best regards,
Peter

Prototype pcb product line

mohammadyou

Member level 4

tpetar

Advanced Member level 7

mohammadyou

Member level 4

tpetar

Advanced Member level 7

mohammadyou

Similar threads

Prototype pcb product line

mohammadyou

Member level 4

tpetar

Advanced Member level 7

mohammadyou

Member level 4

tpetar

Advanced Member level 7

Similar threads

Privacy & Transparency

Privacy & Transparency