Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

proteus header design

Status
Not open for further replies.

omerzora

Junior Member level 1
Junior Member level 1
Joined
Mar 7, 2010
Messages
17
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Location
istanbul
Activity points
1,453
Hi all,

I have a problem with Isis Proteus Header design. I want to design a header for a3 paper. I have added component style box from 2d graphics box mode to determine the borders of my design. It is already working.

**broken link removed**

I want to save this design as template. If it is used as it is, isis takes these borders as components. When click selection is used, these borders are copied or cut with real components. Do you have any solution for this?
 

I don't understand why you have drawn lines to define the borders,
if you open the system -> set sheet sizes... menu you can select A3 and then use the shown borders.

Alex
 

I can do it but there are lots of designs that i and my colligues drawn and i want to standart all of these. There are tamplates that created by isis but i don't want to use it because author or doc.no. or revision information cannot be used in my proteus. Note: i use proteus 7.7 sp2
 

hey master's I am sorry if i posted on the wrong thread...

I have a problem with my proteus 7.7
whenever I click on my work sheet, my component, or design, were all lost...
I need you're help master's...

again sorry if I posted on the wrong thread...
:( :( :(
 

hi amadjo01

i think you should have a new post and explain your problem clearly.
 
  • Like
Reactions: mmaun

    mmaun

    Points: 2
    Helpful Answer Positive Rating
hi amadjo01

i think you should have a new post and explain your problem clearly.

okay sir, but i will search the thread first, so that i will not jeopardize the question.. thank you sir :grin: 8) 8)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top