Proteus 7.1 Serial Port connection

Status
Not open for further replies.

neoaspilet11

Full Member level 5
Joined
Sep 29, 2005
Messages
277
Helped
29
Reputation
56
Reaction score
8
Trophy points
1,298
Location
Cebu, Philippines
Activity points
4,048
proteus serial port

Hello,

Is it possible to connect the Proteus simulation to actual serial port of the computer? (connecting virtual terminal to actual serial port)

Any ideas are welcome.

Thanks,
 

compin proteus

That would be good. But I cant find where it is. Is it a property on the Virtual Terminal.

Pls help. Thank you


OKAY i see it now. Thnak you Very much

Added after 1 hours 33 minutes:

Follow up Question

How to use the COMPIM?

1.) My set up is shown in the image
2.) When COMPIM is not connected and I have to manually enter the host response from the Virtual Terminal, the simulation is OK. But with the COMPIM connected the MCU enters to hang state.

3.) Is my configuration correct?



Thanks

 
proteus compin

Can u interchange the rxd and txd line and try it
 

    V

    Points: 2
    Helpful Answer Positive Rating
compim serial port model

At Proteus, there is a simple compim demonstration of how the this model may be used. It helps.
 

proteus isis txd rxd

Yeah But sometimes the COMPIN does not correctly outputs serial stream to the target device. Is teh COMPIN model have some limitations? or is it stable. because the echoed data back to proteus is not the same as teh actual output..
 

seriales de proteus 7.1

Sounds like the handshaking or buffering config is incorrect.

Suggest you edit the COMPIM part and launch the help file.

Iain.
 

Status
Not open for further replies.

Similar threads

Cookies are required to use this site. You must accept them to continue using the site. Learn more…