Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Programming the usb for data transfer

Status
Not open for further replies.
V

vaishu.fun

Newbie level 1
Newbie level 1
Joined
Mar 11, 2013
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,286
Hi.. I am going to be implementing a sequence generator in fpga altera cyclone II board and i need to transfer the sequence to the PC via USB. I undertand that i need to program my usb port in order to do this using c or c++... but I am new to this so can someone please help me on where to start? If possible can we do this programming in matlab which i prefer?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top