dum311
Junior Member level 1
i am using CADSTAR software to design the impedance matching transformer IFT component
as shown in the link below:
i am not very sure about the dimensioning of the circle pads
this is the link:
if possible,do you have the symbol part and component part of this impedance matching transformer IFT?
i am looking forward to your replies as soon as possible.
thank you very much
as shown in the link below:
i am not very sure about the dimensioning of the circle pads
this is the link:
if possible,do you have the symbol part and component part of this impedance matching transformer IFT?
i am looking forward to your replies as soon as possible.
thank you very much