Problem with simulation in ORCAD CIS Capture using PSPICE

[savan]

I am designing DVCC block on CIS capture (proposed by Elwan and Solimon)

I am facing following error after I save my design and ORCAD closes afterwards.

Any hints suggestions?
Thanks in advance

Similar post was also started but has not been solved yet!
please help!

 

[sarvanbhakya]

Two reason one is ur orcad is not installed properly or UR processor pblm

 

[abhajn]

To check your installation, you could open one of the example designs shipped with Capture.
(They are located at <installation folder>\tools\pspice\capture_samples\anasim)
If they work, then the crash could be design-specific.