Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] problem with PGM pin (15th pin ) of PIC4520

Status
Not open for further replies.
Raady Here

Raady Here

Full Member level 5
Joined
Jun 8, 2013
Messages
242
Helped
26
Reputation
52
Reaction score
26
Trophy points
28
Location
India
Activity points
1,571
PIC18F4520
MPLAB 8.8

Hi,

I working with 32 leds connected to 32 port pins. LEDs toggle according to the requirment.
For 15th pin of the MC (RB5/PGM), I am not able to use this.
I have probed at pin, even if I program the pin to be high it doesnt show any voltage and LED doesnt glow.
How can it be made digital i/O pin

Regards,
Raady
 

this is from the manual :

23.9 Single-Supply ICSP Programming
The LVP Configuration bit enables Single-Supply ICSP
Programming (formerly known as Low-Voltage ICSP
Programming or LVP). When Single-Supply Program-
ming is enabled, the microcontroller can be programmed
without requiring high voltage being applied to the
MCLR/VPP/RE3 pin, but the RB5/KBI1/PGM pin is then
dedicated to controlling Program mode entry and is not
available as a general purpose I/O
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top