Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi every one,
I have a STM32H743VI which pin 24 (PA2), 60 (PD13) and 76 (PA14 which is programmer SWCLK pin) are connected to the GND pin.is that mean is microcontroller burnt out.
I have bought it recently and had not used it.
You have baught a bare IC and tested all 100 pins with an Ohm-meter?
Against what? With what method/current?
What is the measurend resistance?
Following ESD protection rules?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
