Codeman
Member level 2
I had build this circuit baut it does not work.
The signal is changing from 0 to 5V at R1 pin, but the transistor does not change state. It is allways on.
The transistor is logic level, P-channel, 30V, 3A.
I was thinking that using a logic level transistor was ik to switch 24v loads.
Do I have to use a N-Channel to do this?
I already have the PCB manufactured
Thanks in advance
The signal is changing from 0 to 5V at R1 pin, but the transistor does not change state. It is allways on.
The transistor is logic level, P-channel, 30V, 3A.
I was thinking that using a logic level transistor was ik to switch 24v loads.
Do I have to use a N-Channel to do this?
I already have the PCB manufactured
Thanks in advance