Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with designing in Intellisuite.

Status
Not open for further replies.
B

bari_904

Newbie level 1
Joined
May 18, 2011
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Kuala Lumpur, Malaysia
Activity points
1,287
I'm designing a touch mode pressure sensor using the 3D builder software in Intellisuite. Every time i try to export the model to the ThermoElectroMechanical simulation, after i run the analysis i get the same error everytime "Result file not found"
I would like to know if its a mistake with my model or the software's error.
Thank you.
 

I don't understand that you get the error in TEM or in 3D Builder?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top