bari_904
Newbie level 1
- Joined
- May 18, 2011
- Messages
- 1
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Location
- Kuala Lumpur, Malaysia
- Activity points
- 1,287
I'm designing a touch mode pressure sensor using the 3D builder software in Intellisuite. Every time i try to export the model to the ThermoElectroMechanical simulation, after i run the analysis i get the same error everytime "Result file not found"
I would like to know if its a mistake with my model or the software's error.
Thank you.
I would like to know if its a mistake with my model or the software's error.
Thank you.