I am going to design a BPF, the center at 26MHZ, span with 2MHZ.
After using ADS, I got the result at folling link. **broken link removed**
But, I found the value of L2 is too big.
It seems to effect the INSERTION LOST, and hardly make it.
How to revise it to better value?
Could you please tell me how to use the optimum setting?
Please refer to as following link. **broken link removed**
I was confused in GOAL setting and optimum setting in ADS.
Please give me explanation in details and step by step description as possible.
Appreciated.
That IS a big one. You could transform down in impedance, hit the filter, and transform back up again. You could change to a different filter topology. You could play around with the ripple allowed to get some relief.
really?
I don't know ADS is not suitable for filter design.
Which aspect is its strength?
I don't have ansoft, could you help me to design my BPF, 26MHZ center, 2MHZ SPAN?
Appreciated.
Added after 43 seconds:
really?
I don't know ADS is not suitable for filter design.
Which aspect is its strength?
I don't have ansoft, could you help me to design my BPF, 26MHZ center, 2MHZ SPAN?
Appreciated.