Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problem in reuse -PADS 2005

Status
Not open for further replies.

Monolisa5791

Member level 3
Member level 3
Joined
Jun 14, 2006
Messages
65
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,962
pads 2005 reuse

Hi All,

I am using pads 2005 sp2 I need to reuse the traces from one design to another design.I have tried it with the REUSE option in PADS. Traces comes and place in the exact location of the center of the drill and also the location of traces matches. But still TACKS are showing in the entry of the PAD and connectivity doesn't comes. Let us know anyone how to solve this problem.

Regards,
Monolisa
 

reuse design

Just export the ASCII from the board file after reuse and agian import the ASCII in to the board file.
 

pads pcb reuse 2005

First, select the traces needs to be reused and save that resue file. After that select the option "reset origin" and select the origin 0,0. again save that reuse file.
In your new board, use that reuse section with the origin of 0,0. It will work.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top