shobhitsriv
Newbie level 4
I had been using a VIRTEX_II pro development board and it had been working fine , but recently I had to change it (but still its another VIRTEX-II pro development board).
Now, when I try to program it using JTAG then it shows the following error
Cable connection failed.
PROGRESS_END - End Operation.
Elapsed time = 7 sec.
Cable autodetection failed.
WARNING:iMPACT:923 - Can not find cable, check cable setup!
Can anyone help me out here?
Now, when I try to program it using JTAG then it shows the following error
Cable connection failed.
PROGRESS_END - End Operation.
Elapsed time = 7 sec.
Cable autodetection failed.
WARNING:iMPACT:923 - Can not find cable, check cable setup!
Can anyone help me out here?