olaoni
Newbie level 1
Hi,
I am using the cc1000pp module interfaced to a PIC18 series. I can read and write all registers successfully. The problem I am facing is that the clock is always running in both RX_MODE and TX_MODE hence I am getting in junk data through my DIO pin.
I am using Manchester encoded mode. Frequency 433.134MHz Any help is highly appreciated.
I am using the cc1000pp module interfaced to a PIC18 series. I can read and write all registers successfully. The problem I am facing is that the clock is always running in both RX_MODE and TX_MODE hence I am getting in junk data through my DIO pin.
I am using Manchester encoded mode. Frequency 433.134MHz Any help is highly appreciated.