Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
you have a choice of linear passive methods or switching. The passive is easiest, but will generate heat. The switching is more efficient.
Whichever method you select, protecting the input is most important. There can be big spikes on the 12 V line when you start your car.
Put a pi filter on the input with shunt capacitors of large value and a big inductor. This will remove most of the spikes. Then put a zener at 15 V across the input. Use a power type, not the 400 mW types.
You can also get MOV type suppressors for this voltage range.
If you want your power supply to work during motor starting, you need to use a low dropout regulator instead of a standard as LM7805.
In very cold weather the battery could drop down to 6V.
Use an automotive regulator from Infineon, St or National instead.
The are better protected against battery reversal, line transient and load dumps.
Read more in https://www.st.com/stonline/books/pdf/docs/1691.pdf
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.