eem2am
Banned
hello,
I am designing an offline boost, active power factor corrector using L6561 IC.
When i set the zero gain crossover frequency, must it be.....
1. At a frequency of about 10 Hertz ?...or...
2. At a frequency which is lower than the corner frequency of the output RC filter ?
I am designing an offline boost, active power factor corrector using L6561 IC.
When i set the zero gain crossover frequency, must it be.....
1. At a frequency of about 10 Hertz ?...or...
2. At a frequency which is lower than the corner frequency of the output RC filter ?