I have recently purchased a drum machine off ebay with a broken LCD. I searched around on the internet for a replacement LCD of the same type but couldn't find anything.
However I did find one that is the same resolution for Arduino projects. It is a 240 x 64 resolution graphic LCD.
The problem is the Drum Machine has 10 pins from the mainboard to the LCD module, where as the Arduino LCD module has 20 pins.
Now I would like to know if it is possible to connect the 10 pins that the broken LCD module uses to the 20 pin Arduino LCD module, and whether it would work?
I have attached the pin out diagram and schematic for both units. Any help would be greatly appreciated
Unfortunately you need to find one with the correct interface. I guess the Akai is serial but from the naming I am not sure which type. The Arduino one is parallel.
Unfortunately you need to find one with the correct interface. I guess the Akai is serial but from the naming I am not sure which type. The Arduino one is parallel.
Yeah that was one option but not for that price lol.
Is there anyway for example to build / buy a serial to parallel converter. Just trying to weigh up my options before considering to bite the bullet and buy the overpriced replacement
If you can find out what the protocol/interface of the old LCD is then anything is possible. If it is I2C, for example, you could use a microcontroller to take the I2C data from the Akai and send it to a parallel LCD and send the appropriate response back. Quite a project though, even when you have the data.
Are there any identifying marks, names or numbers on the old LCD? If you could identify it then it would be a good start.