Positive Cross Current Limit Circuit. Agilent 6611-6613C and 66309D

Status
Not open for further replies.
J

Jester

Full Member level 6
Joined
Aug 18, 2012
Messages
377
Helped
7
Reputation
14
Reaction score
7
Trophy points
1,298
Location
.
Activity points
4,754
I'm trying to locate this Positive Gross Current Limit circuit (Voltage clamp) on an "A1' board that is used in Agilent 66309D, 6611-6613C power supplies. No U# on the block diagram and I probed every diode I could find WRT D321 Anode and I can't find it. I'm pretty sure The ?? voltage clamp is pulling down the control signal at its anode, however I have had no luck finding it on the board.
 

Attachments

  • Voltage clamp.png
    69.1 KB · Views: 142

Look in the area shown.
 

Attachments

  • Max_I_lim.png
    106.7 KB · Views: 116
Reactions: Jester

    J

    Jester

    Points: 2
    Helpful Answer Positive Rating
E-Design,

I should have mentioned that I have the SMT (not through hole) version of the A1 board.

Any chance you have the SMT version?

I'm curious where did you get that document (I have searched high and low)?

Very much appreciated
 

I can't remember where I downloaded it on the web. I only have the old thru hole version sorry.
 
Reactions: Jester

    J

    Jester

    Points: 2
    Helpful Answer Positive Rating
Is there a document name or number?

Perhaps if I search for the document name I will find it?

Any idea what op amp they used, that might help?

Thanks again.
 

There is an HP part number on the diagram. You could look up the industry equivalent on the web.

I think that I just would have searched for 66312A or HP66312A.
 

Attachments

  • Max_I_lim_sch.png
    77.2 KB · Views: 114
Reactions: Jester

    J

    Jester

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…