Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

port inhomogeniously filled error

Status
Not open for further replies.

sauravgupta

Newbie level 1
Joined
Aug 11, 2013
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
7
pls tell me smone....
in cst
what is port inhomogeniously filled with in the first 3 mess cell.?
 

I am not sure, but have you tried increasing mesh cells or mesh line limit ratio!
 

The first change after Cross section of the port you are defining, is the problem
the port must maintain its shape at least for a few mesh cells.
Then you may increase the distance between the port and that first change.
I wish it will work...
 

You can also change the reference plane and use a longer feed line. Or increase locally the mesh cell density.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top