Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, antaryami.mt.er09.
Before simulation you need to save current, because by default only node voltages are saved, not currents. Do Outputs->To be saved->Select on schematic and click on the current you want to save. When performing tran analysis you can also go into tran analysis options and select Output parameters->save->all. In this case it would save all currents and voltages.
Regards.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
