Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

please help me ,how to get information about location/tower using at commands

Status
Not open for further replies.

silvanose

Newbie level 1
Joined
May 13, 2008
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,285
please help me ,how to get information about location/tower using at commands
 

ckshivaram

Advanced Member level 5
Joined
Apr 21, 2008
Messages
5,070
Helped
2,146
Reputation
4,298
Reaction score
2,087
Trophy points
1,393
Location
villingen (Germany) / Bangalore
Activity points
30,097
As discussed from past many years , there is not AT command to give you the location or area name directly... you get the mean of the 3 or 4 towers in an very very long format of data....

So dont waste time in running behind this concepts.... mobile phones uses its intelligent algorithm to decode the response and print the code name...

+CREG notification includes the location information of currently "connected" cell in numeric form......
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top