Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Placing Resistor and Capacitors in NWell In Layout

Status
Not open for further replies.

Puppet123

Full Member level 6
Full Member level 6
Joined
Apr 26, 2017
Messages
356
Helped
22
Reputation
44
Reaction score
21
Trophy points
1,298
Activity points
4,345
To reduce noise coupling it is said to put resistors and capacitors in nwell in layout.

What is nwell tied too ? Is nwell also surrounded by nwell guard ring? So what is nwell guard ring connected to ? It should be quiet - so analog ground ?

The application is for a SAR ADC's capacitive DAC.

If cap and res are three terminal devices in kit - what is third terminal connected to if placing them in nwell ?
 
Last edited:
In order to provide isolation, the nwell should be connected to the most positive supply terminal, together with the third terminal of the passive devices. By using the same reference for nwell and third terminals you achieve the same quietness as if these devices were in a grounded pwell. Don’t forget to connect by metal.

Still more noise decoupling (from lateral effects) is possible by surrounding the nwell by a p+ guard ring at (metal-connected) analog ground, with a bit more than minimum spacing - if you allow for the additional area consumption.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top