savethewales
Newbie level 1
Hi Everyone,
i'm trying to make piezoelectric pump which includes a piezoelectric disk and a driving board.
unfortunately my knowledge of electronics is only slightly more than zero so i need some professional advice.
in general i want to replicate the driving board which looks like this:
from description:
...It converts a single 2.5 - 6 VDC power and generates a drive voltage of 215 Vp-p at frequency of around 40 Hz...
...power consumption 100mW...
regular sine wave is acceptable.
So I see 5 components. Can anybody suggest the wiring scheme between this 5 components with values assigned to them?
If U1 is microcontroller what kind of signals should it generate (sine wave is required in the end)?
Any ideas are very welcome
Thanks
i'm trying to make piezoelectric pump which includes a piezoelectric disk and a driving board.
unfortunately my knowledge of electronics is only slightly more than zero so i need some professional advice.
in general i want to replicate the driving board which looks like this:
from description:
...It converts a single 2.5 - 6 VDC power and generates a drive voltage of 215 Vp-p at frequency of around 40 Hz...
...power consumption 100mW...
regular sine wave is acceptable.
So I see 5 components. Can anybody suggest the wiring scheme between this 5 components with values assigned to them?
If U1 is microcontroller what kind of signals should it generate (sine wave is required in the end)?
Any ideas are very welcome
Thanks