[PIC] PIC18F Usb Communication With Labview

[daniii]

Hi Everyone,
I am newbie to USB Communication and don't know much about LAB VIEW's USB VISA. Have worked on Micro Controller and Labview a little though. I want to know how send data from pic18f2550 that can be shown in Labview even if its just some sensor value and to send command from Labview to PIC18f2550. I want to do USB Communication. I'll be very thankful if you can help me. Thank you

Regards,
Meer

Student of Electronics Engineer

 

[hamed8419215]

hi daniii

if you have not enough knowledge about USB communication, its better to use USB to UART ICs to send and receive data over USB.
then you can use a low cost MCU without USB module.