Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PIC16F627A o/p current

Status
Not open for further replies.

hemnath

Advanced Member level 2
Joined
Jun 24, 2012
Messages
676
Helped
61
Reputation
120
Reaction score
57
Trophy points
1,308
Location
Chennai
Activity points
6,410
check datasheet of your microcontroller and look into electrical specifications page no. 135. It will be helpful for you :)
 

Tahmid

Advanced Member level 5
Joined
Jun 17, 2008
Messages
4,758
Helped
1,791
Reputation
3,574
Reaction score
1,650
Trophy points
1,393
Location
Silicon Valley, California, USA (from Dhaka, Bangl
Activity points
30,545
Maximum current sourced/sunk on any IO pin is 25mA. Remember that output voltage decreases with increasing current. So, when drawing 25mA current, voltage at pin may be significantly lower than 5V.
Maximum current sourced/sunk by PORTA/PORTB is 200mA.

You can find this information in the datasheet under "ELECTRICAL SPECIFICATIONS".

Hope this helps.
Tahmid.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top