Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PIC16F627A o/p current

Status
Not open for further replies.
check datasheet of your microcontroller and look into electrical specifications page no. 135. It will be helpful for you :)
 

Maximum current sourced/sunk on any IO pin is 25mA. Remember that output voltage decreases with increasing current. So, when drawing 25mA current, voltage at pin may be significantly lower than 5V.
Maximum current sourced/sunk by PORTA/PORTB is 200mA.

You can find this information in the datasheet under "ELECTRICAL SPECIFICATIONS".

Hope this helps.
Tahmid.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top