Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PIC Programmer showing error

Status
Not open for further replies.
S

Sudhp

Member level 4
Joined
Oct 11, 2013
Messages
69
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Location
India
Activity points
528
Hello Everyone,
I am trying to program controller ic PIC16f72 using TL866CS Universal programmer. I have used same code before with another programmer and that was working completely fine. With this programmer showing this error and ic (After programming) not working.
PIC16f72.PNG

Any suggestion will be appreciable .
 

You are setting the Fuse bits, but it is not clear whether you are protecting against reading or not. Note that the 'verify after' option is checked, which would explain this error. In general the 0x3FFF (every bits on data bus equal '1') that we se at the above window is what programmer read whenever the Code Protect fuses are set.
 
  • Like
Reactions: Sudhp

    S

    Sudhp

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top