KlausST
Advanced Member level 7
Hi,
Yes, you can connect the data lines from ADC to FTDI... just read both datasheets on timing.
A simple pld could do the job.
********
FT2232H: Last week we did some tests.
With FPGA to a Linux PC we achieved about 11MBytes/s. With dual 245 FIFO mode, traffic only on one channel in one direction.
Using 4kbytes blocks with echoing through FPGA (traffic from PC via FTDI and back on the same channel) we achieved a bit more than 4Mbytes/s.
Just as first test without any optimisations. FPGA was clocked with about 100MHz.
Klaus
Yes, you can connect the data lines from ADC to FTDI... just read both datasheets on timing.
A simple pld could do the job.
********
FT2232H: Last week we did some tests.
With FPGA to a Linux PC we achieved about 11MBytes/s. With dual 245 FIFO mode, traffic only on one channel in one direction.
Using 4kbytes blocks with echoing through FPGA (traffic from PC via FTDI and back on the same channel) we achieved a bit more than 4Mbytes/s.
Just as first test without any optimisations. FPGA was clocked with about 100MHz.
Klaus