chevymn1964
Full Member level 2
- Joined
- Apr 1, 2006
- Messages
- 120
- Helped
- 2
- Reputation
- 4
- Reaction score
- 0
- Trophy points
- 1,296
- Location
- Santa Rosa, Ca.
- Activity points
- 2,551
Hey everyone.... Im working on a new one now and I just wanted to get some input.... Ive been thinking of building a "dummy" load for test. I am thinking of using a PIC16F676 to read and display voltage and current... I was thinking of using the pic to limit the current by using PWM and shunting a MOSFET through a limit resistor to ground. But I dont know it the PIC would be fast enough to read the ADC's for curent & voltage and display it on a LCD then run the PWM? Would I be better off using a PIC with a built in PWM? Any ideas?