Pic !8f4550 I want to blink some led

[jsureshp]

please anybody help me please
I'm using the Mplab ide and hitech c compiler
Pic 18f4550

 

[jsureshp]

is there any alternative software for Mplab Ide?

Added after 3 minutes:

The source file i added
and how can i add the header file?
where it will be available

 

[VINITA DHAMELE]

MPLAB IDE is good enough for PIC.
you can install the upgraded version of c compiler.
I use CCS C compiler and there is full support for 18f series.
or as millwood says try to use address instead of names e.g address of Porta .

As Error Message says: unable to locate htc.h & delay.h

find these files are supported by your compiler or not?

Regards.

 

[jsureshp]

Actually
My compiler not show the header file.
It shows from pic 12series to pic 16series only can you tel the upgrade version for the c compiler
or give the link for the version for the pic

 

[123jack]

I recommend mikroElectronika
Free to use (up to 2K) compilers and very nice IDE
Excelent support.
Give it a go

jack

 

[jsureshp]

the header file for pic 18series are not availlble in my system

Added after 1 minutes:

That means Mikro c software
correct?

 

[VINITA DHAMELE]

you can visit the site of Microchip.
www.microchip.com
www.ccsinfo.com
you will find there latest version of ccs c compiler but you have to get license from ccs.

if your application is small enough you can go for the free version of mikroElectronika as 123jack suggests.

regards.

 

[jsureshp]

ok
shall you give the hex file for blinking led

Added after 11 minutes:

and i also installed the ccs compiler for pic
this also showing the header file from pic 12series to pic 16series only

Added after 35 seconds:

now what i do?

Added after 18 minutes:

now what i do?

Added after 38 minutes:

now what i do?

 

[millwood]

now what i do?

prey for a pie to fall out of the sky.

 

[Ichan]

From your picture, the code is written for Hi-Tech PICC18 compiler but the compiler used is Mplab C18. You use wrong language toolsuit.

-ichan

 

[123jack]

Go to the mikroElekronika web site and download (yes) MikroC
Open up the example files and compile one of the two LED blinking
examples given.

jack

 

[VINITA DHAMELE]

ok
shall you give the hex file for blinking led

Added after 11 minutes:

and i also installed the ccs compiler for pic
this also showing the header file from pic 12series to pic 16series only

Added after 35 seconds:

now what i do?

Added after 18 minutes:

now what i do?

Added after 38 minutes:

now what i do?

if you have installed a latest version of CCS C Compiler then there is no point why you don't have 18 series header file?

in your project wizard choose proper language toolsuite.

Recheck your project settings ( proper compiler ,device ,language toolsuite) .

Hope this will help you.
Regards.