PCB four 80 mill wide traces

Status
Not open for further replies.
S

saramah

Member level 3
Joined
Apr 25, 2018
Messages
64
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
689
hI
Here,
https://www.edaboard.com/showthread.php?228130-Pcb-trace-width-for-10a-current DeLorean said,
What is mean by four 80mill? Is it like, mask-80-mask-80-mask-80-mask-80-mask on a surface(top/or bottom). if so then what should be the mask width?
tnx.
 
Last edited by a moderator:

It means four traces 80 mil wide, 320 mil in total... Not really recommended for 40 A.
Look for Saturn PCB Toolkit, download it and have a play.
 

Although solder has about 10 time higher resistivity compared to copper, you can put a very thick bead of solder on the copper layer. This is the common trick used in SMPS for desktop computers.
 

hi,
If resistivity of solder is more than CU, then resistance will be more and curren will down, so, how thick bead of soldere on cu will carry more current??
tnx
 

saramah said:
If resistivity of solder is more than CU, then resistance will be more and curren will down, so, how thick bead of soldere on cu will carry more current??
tnx
Click to expand...

Simple Suppose your cu track have 0.1m Ohm resistance, your solder mask (bead ) have 1 m ohm then effective resistance will be 0.09 m ohm
We can increase the thickness of solder mask so the resistance will reduce
 

c_mitra said:
Although solder has about 10 time higher resistivity compared to copper, you can put a very thick bead of solder on the copper layer. This is the common trick used in SMPS for desktop computers.
Click to expand...

Bad Advice, do the job properly with copper, this will not pass UL or other safety measures.
 

this will not pass UL or other safety measures.
Click to expand...

Can you please tell which specific test it will not pass?

These standards are basically safety features and putting a thick solder bead does not compromise the safety otherwise.
 

You cannot use it for extra current capacity. Its an old practice that went out of date 25+ years ago. Calculate the correct copper required at the required max temp rise and do the job properly. Its hard to control the amount of solder added and iit is an extra production job if wave soldering is not used.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…