Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PCB Copper thickness and frequency relation

Status
Not open for further replies.

VJKris

Member level 1
Member level 1
Joined
Jun 22, 2012
Messages
33
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,530
Hi Experts,

Is there any relation between Cu thickness and frequency of the signal?
I am confused on choosing 0.5 oz or 1 oz or 2 oz inner and outer layer.

Based on what parameters we can decide the Cu thickness?
My board runs at 20 GHz speed.

Regards,
VJ
 

Hi,

Have a look on this thread.Mostly similar to what you have asked. Might help you in some ways

https://www.edaboard.com/threads/50039/

I don't think the change in copper thickness will impact frequency.
Cu thickness is mostly based on the Current rating we use.

SHABU
 
Last edited:

Can effect the impedance calculation, otherwise pick a copper thickness based on feature size and current requirements.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top