Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

parking system using pic 18f4520

Status
Not open for further replies.

karam alomari

Newbie level 2
Joined
Apr 18, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,296
This project calculates the time of entering the car to the parking and the time to go out and calculates the cost.
When a car enter the park , the IR beam between the transmitter and receiver will be disconnected. The disconnection will trigger the interrupt which will save the arrival time from RTC to the EEPROM ,
The same configuration is set at the exit .. but this time we get the time of departure and save it to the EEPROM … the we subtract the two values and Multiplication to Tariff rate and calculate the cost and show the time and the value of cost on the screen


Component
Pic18f4520
voltage regulation 7805
lcd 16x2
Real time clock(RTC)
IR sensor (transmitter & receiver)

i don't know how write the code to program the pic and simulation please help me>>>
 

h.sharma

Junior Member level 3
Joined
Jun 16, 2012
Messages
30
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,455
first of all you should have knowledge of how to interface lcd, rtc to pic. rtc communicate via i2c protocol. lcd has special commands to interface.
Programming is done on Mplab ide or any other compiler.
Have u done some work on pic before?
initially try simple interfacing of lcd, rtc etc. on pic simulator or proteus.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top