Hi,
This is AV connector( RCA Jack).
Problem is height.
The top side of this around 13.2mm from the pcb.
My plastic model will be made of PLA or ABS material having 1.5mm thickness.
So, total height is 13.2+1.5=14.7mm from pcb.
My switch is having 14mm height from pcb.
So, should I reduce the thickness of model and/or I reduce height by doing this:
?
I will push Av connector little outside of pcb so that the block will on outside of pcb.
Will this cause any problem?
I will change pcb hole only size for av connector.
I found I can reduce size by 1.4mm (by scaling image and measuring distance).
Switch head will 0.8mm from case[14-(13.1+1.5-1.4)]=0.8mm.
Is it good enough distance for pushing switch ?
Thanks