[SOLVED] pad and via holes in altium 18

Status
Not open for further replies.

amin_sa

Newbie level 2
Joined
Jun 25, 2018
Messages
2
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Activity points
14
I'm working with Altium 18.
pad holes are not visible as shown in figure below


anybody knows how to make the holes visible?
thanks in advance
 

Did you try by checking "drill drawing" at View Configuration panel, Board Layers and Colors tab ?
 
Yes it is checked andre!
But I found it!
I knew that I should check "pad hole" and "via hole" somewhere to make them visible.
I had looked at View Configuration several times before but I couldn't find them.
After you referred me to this panel again I found their locations accidentally.
They were collapsed under "system colors" as shown in picture below

As I click on it the picture below appears and I can check them


Thank you andre for your help.
 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…