Hi,
I am trying to use a mosfet as schematic but in benchmark this is showing 8V in "Node1" which I think should be 0V, and It can turn on a LED also. I think the schematic is ok(I got it in another post) but I am not sure why this is happening. I measured the current for BLUE LED which it is showing 30mA and I think it couldn't be the IDSS!
Exactly I have a NPN to turn it on which is working properly.
I would like to draw your attention I have this problem when I disconnect that path also.
Your circuit has no value for R2 the load. Is it 22M ohms?
You talk about a blue LED but there is no blue LED in the schematic. Where was it connected?
I got the point from FvM and changed the supplier of the mosfet and solved.
Seems it was fake and not original.
For a test I changed the VCC to 12V and it worked ok, it shows it can't do 24V.
Then I replaced the mosfet with a new one (which I think is original) also VCC to 24V and it is working properly.