Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Orcad Segment width violation error?

Status
Not open for further replies.
R

rsashwinkumar

Member level 4
Member level 4
Joined
Jun 25, 2011
Messages
70
Helped
11
Reputation
22
Reaction score
11
Trophy points
1,288
Visit site
Activity points
1,825
Hi,

I am using Orcad Layout; When I was trying to change the widths of some segments I get a DRC error saying "Segment width violation". This is happening to only some segments not all. Has someone faced the same issue? Plz help me with this..
 

Unmark or deselect the DRC tool and change the width of the segment and after done all changes and go to the DRC rule and select the rules which is required.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top