Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

OrCAD pspice output parameter lin0/sat1

Status
Not open for further replies.

Sakr

Member level 2
Joined
Jul 9, 2005
Messages
43
Helped
11
Reputation
22
Reaction score
5
Trophy points
1,288
Location
Cairo, Egypt
Activity points
1,536
orcad parameter operation

Some one told me that lin0/sat1 parameter tells the operation region of the mosfet; linear or saturation.

1. is that true??
2. If it is true I always get a value of -1.00E00, what does it mean??!!

If any one have a description to all output file parameters please upload it.

Help, please...
 

ahmad_abdulghany

Advanced Member level 4
Joined
Apr 12, 2005
Messages
1,209
Helped
102
Reputation
206
Reaction score
21
Trophy points
1,318
Location
San Jose, California, USA
Activity points
11,807
lin0/sat1

I heared that also ..
Assume it is wrong can't we invent an automated method to check for every MOSFET whether it is saturation or linear (triode).. I don't know exactly how but i am thinking that it can be done by making a small Matlab funciton that reads the output file or even the part that describes bias (Vgs, Vth, and Vds for each MOSFET) then make small calculation for each one making the suitable decision that the MOSFET is Linear if Vds<Vgs-Vth and it's saturation if Vds≥Vgs-Vth..

I hope you can get it and can give help..
Thank you very much..
Note it is now mainly Matlab problem now!
Ahmad,
 

    Sakr

    points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top