Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

OrCAD PSpice out message ?

Status
Not open for further replies.

mohazaga

Full Member level 2
Joined
Aug 18, 2005
Messages
141
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
2,397
HI ,
I got the following message when I simulate a circuit :
Mosfet M_M2, model PMOS: Pd = 0 is less than W
Mosfet M_M2, model PMOS: Ps = 0 is less than W
Parameter XW in model PMOS is invalid - Ignored
Mosfet M_M1, model NMOS: Pd = 0 is less than W
Mosfet M_M1, model NMOS: Ps = 0 is less than W
Parameter XW in model NMOS is invalid - Ignored
So , what does it means?
Thanx
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top