Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Orcad Pspice digital control loop programming

Status
Not open for further replies.
G

GeoAVR

Member level 2
Member level 2
Joined
Jun 4, 2014
Messages
48
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Visit site
Activity points
366
Hi,

I want to implement a digital controller for a switch mode power supply in Orcad pspice.

The controller will take voltages and current values as inputs and create the control signal using intelligent algorithms (state machines, digital control techniques etc).
Therefore I need a block that runs a code for processing these values (ie. C programming code).

Is there a way to implement this and how?

Best regards,
G
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top