Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Orcad is not using my own jumper library during auto routing

Status
Not open for further replies.
E

embedded.subscription

Newbie level 2
Joined
Nov 15, 2009
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Kolkata
Activity points
1,296
Dear Friend,
First of all, thanks a lot for the steps given ( by parinda )for single layer board design in orcad. If i follow the steps i can make the board without any problem. But , if i change the footprints of the jumper (e.g. JUMPER300 etc.) - orcad is trying to do the layout without using any jumper (and ultimately failed to acheive 100% routing). Is it possible to make my own jumper library and orcad will use only these jupmers during auto routing (i have tried and failed in Orcad 9)? I can't understand the mistakes i am doing. Pls guide me.

Regards,
Kaushik.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top