embedded.subscription
Newbie level 2
Dear Friend,
First of all, thanks a lot for the steps given ( by parinda )for single layer board design in orcad. If i follow the steps i can make the board without any problem. But , if i change the footprints of the jumper (e.g. JUMPER300 etc.) - orcad is trying to do the layout without using any jumper (and ultimately failed to acheive 100% routing). Is it possible to make my own jumper library and orcad will use only these jupmers during auto routing (i have tried and failed in Orcad 9)? I can't understand the mistakes i am doing. Pls guide me.
Regards,
Kaushik.
First of all, thanks a lot for the steps given ( by parinda )for single layer board design in orcad. If i follow the steps i can make the board without any problem. But , if i change the footprints of the jumper (e.g. JUMPER300 etc.) - orcad is trying to do the layout without using any jumper (and ultimately failed to acheive 100% routing). Is it possible to make my own jumper library and orcad will use only these jupmers during auto routing (i have tried and failed in Orcad 9)? I can't understand the mistakes i am doing. Pls guide me.
Regards,
Kaushik.