Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

omg!!!! how much current will make a person tremble?

Status
Not open for further replies.

W_Heisenberg

Full Member level 4
Joined
Feb 27, 2011
Messages
217
Helped
6
Reputation
12
Reaction score
6
Trophy points
1,298
Location
Boston
Activity points
2,575
I know the voltage on me is 60V rms. But how much current draw in my body?


Srsly, lab is dangerours.
 

Current draw depends on your resistance. The safe contact voltage on automotive systems is based roughly on this principle. I think in the US the maximum allowed voltage is 60V, in Europe it is 50 or 55V. I don't think it takes much current to cause damage -- I want to say mA (milliamps) of current is all it takes but I don't remember. If your heart is in the path of the current, it can cause some serious damage.

On most academic laboratories you won't see dc voltages any higher than +/-15V, so the highest differential is 30V and I think this is OK for the OSHA standard in the US.

Be very careful with any high voltages and proceed with caution.

Best regards,
v_c
 

Even below 1 mA you can feel current in your body. That amount just barely lights an LED.

Wet skin reduces your resistance. Puts you at risk of lethal amounts of current.

Put (or hold) a diode in series with the juice. You can read the DC current directly on a meter.

And don't forget the reaction we have when shocked. We pull away quickly, sometimes injuring ourselves or someone else.

Do what electricians do. Keep one hand in your pocket when touching exposed conductors.

For a greater measure of safety, plug risky equipment into a receptacle with GFI (ground fault interrupt).
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top