Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Noise in 2 stage opamp

Status
Not open for further replies.

Chinmaye

Full Member level 3
Full Member level 3
Joined
Jan 18, 2016
Messages
164
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,298
Activity points
3,145
I have built differential input and differential output 2-stage opamp with open loop Low-frequency gain of 60 dB and UGB 600MHz. I have tried to build a closed-loop amplifier of 6DB using feedback resistors. When i do a noise analysis on the op-amp in LT spice, I get a curve as attached. Can someone explain to me why I am getting this?
 

Attachments

  • opamp noise.pdf
    139.6 KB · Views: 180

Looks like unsufficient phase margin at loop unity gain frequency with respective gain peaking. Look at closed loop bode plot first. You should have > 60° phase margin to avoid it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top